Should the Production Riser and Joints be fully Thermal Spray Aluminium (TSA) coated?

Asked by ekwuemesam 5 years, 11 months ago | 1 Answers


1 Answer

0
josvanden 5 years, 11 months ago
  • The Production Riser and Joints shall be fully TSA coated, irrespective of insulation coating application
  • All field joints shall be Thermal spray aluminium (TSA) coated
  • Un-insulated pipe ends and connectors shall be Thermal spray aluminium (TSA) coated
  • The splash zone joints also should be coated with TSA

Related Posts


Turrets - Moorings - Risers overview
Turrets - Moorings - Risers overview

1. Introduction1.1 OverviewThis document describes the development of turret and swivel systems which allow 'n x 360 degrees' rotation have …

Cold weather instrumentation design and the need to perform regular preventive maintenance
Cold weather instrumentation design and the need to perform regular preventive maintenance

The following lessons learned is an example of an industry loss study that determined that instruments in critical service should …