What is your take on the "Flange Type Connectors" and "Pin and Box Type Connectors" for Riser Joints?
Confirm to permanently remove your answer!
* Illustrations taken from GMC Mechanical Connector
Pin and box drilling riser connectors should be weld-on type with the following characteristics:
Well, Flange Type Connectors and Pin and Box Type Connectors are 2 complete different designs even though they are both used for Riser Joints. However, you should use either all Flange Type connectors or all Pin and Box type connectors.
1. Introduction1.1 OverviewThis document describes the development of turret and swivel systems which allow 'n x 360 degrees' rotation have …
The following lessons learned is an example of an industry loss study that determined that instruments in critical service should …