Do pressure relief valves protect systems from very rapid pressurization?

Asked by JanineBennin 4 years, 3 months ago | 1 Answers

Do pressure relief valves protect systems from very rapid pressurization? For example: heat exchanger tube rupture, explosions, accidental vaporization of large quantities of water or light hydrocarbon, etc. Since relief valves do not respond rapidly enough and typically do not have the required flow capacity. Process systems and equipment should be designed where possible to minimize or eliminate potential situations that would result in such very rapid pressurization.


1 Answer

0
aodai 4 years, 3 months ago
A detailed analysis of each plausible situation resulting in fluid discharges into the flare and vent systems should be made to determine the discharge system design rates. When analyzing a single contingency, consideration of all directly related effects, which would potentially involve more than one process unit, should be made (e.g., loss of electrical power or instrument air). A routine flaring or venting event (e.g., compressor down) may be already underway when an unanticipated but related event occurs, and the cumulative impact of all flow should then be considered. Flare and vent systems should be designed for the largest single contingencies. Furthermore, for field developments with multiple platforms having interconnecting gas pipelines, the need to depressure each pipeline through the flare system on one platform due to an incident on the other should be considered in determining the maximum load. Additionally, the controlling case for designing the platform vapor disposal system could be from an inter-field or subsea flowline if the flowline is rated at a higher pressure than the platform piping, and an inlet valve fails.

Related Posts


Design philosophy for the flare, vent, relief, and blowdown systems
Design philosophy for the flare, vent, relief, and blowdown systems

The purpose of this document is to describe the design philosophy for the flare, vent, relief, and blowdown systems. This …

Thermal Insulation Credit for Pressure Relief Valve Sizing Calculation
Thermal Insulation Credit for Pressure Relief Valve Sizing Calculation

Credit factors for insulation in determining the minimum Pressure Relief valve sizes for fire exposure should be as per API …

Definitions of MAWP, MAP, MOP, Design Pressure, Hydrotest Pressure, Burst Pressure, Working Pressure and more
Definitions of MAWP, MAP, MOP, Design Pressure, Hydrotest Pressure, Burst Pressure, Working Pressure and more

Maximum Allowable Working Pressure (MAWP) - maximum gauge pressure permissible at the top of the equipment in its operating position …